Built to fit modular spreader beam hardware, the Machining & Welding Spreader Beam End Cap Pair matches your end cap pair.

This is a wear item on modular spreader systems, and keeping a spare on hand avoids downtime if the fitting is damaged.

It is fabricated from steel, engineered to match standard modular spreader beam dimensions and rated connection points.

Keeping a spare on hand means a damaged connection point does not take a whole spreader section out of service.

This type of lifting equipment is common in facilities that move machinery, structural steel, crates, or bulky components as part of daily operations. Rather than treating each lift as a one-off problem, a dedicated piece of equipment turns it into a routine, repeatable task that any trained operator can complete quickly and safely.

Before putting any lifting equipment into service, verify it matches your hoist or crane setup and confirm the rated capacity covers your heaviest expected load with margin to spare. Routine inspection of welds, pins, and connection hardware helps catch wear before it becomes a safety issue. Keep a simple inspection log if your facility does not already have one, since tracking wear over time makes it easier to plan replacement before a part actually fails in use.

Properly rated hardware, stored and maintained correctly, tends to outlast the equipment it gets paired with. Building a simple habit of checking condition before each use costs very little time and pays off in fewer surprises when a piece of rigging hardware is actually under load.

The specifications below cover everything you need to check compatibility with your equipment.

The Machining & Welding Spreader Beam End Cap Pair is ready to keep your modular spreader beam in service.

Product Info:
•  Style: End Cap Pair
•  Minimum Top Rigging Angle: 45 degrees
•  Shipping Weight: 50 lbs