Built to fit modular spreader beam hardware, the Machining & Welding Spreader Beam End Cap Pair matches your end cap pair.

A replacement fitting like this lets you keep an existing modular spreader beam in service without replacing the entire section.

Steel construction and a secure fit keep this hardware matched to standard modular spreader beam sections.

This is routine maintenance hardware for any shop running a modular spreader beam system regularly.

Equipment like this shows up across a wide range of industries, from steel fabrication and machine shops to warehousing, construction, and vehicle service centers. Anywhere crews need to move a load overhead in a controlled, repeatable way, a purpose-built lift beam or crane keeps the job safer and faster than improvised rigging. Once a facility standardizes on the right lifting equipment for its typical loads, operators spend less time rigging and more time actually getting work done.

Pairing the right lifting equipment with proper technique keeps a shop's safety record intact. Inspect connection points regularly, respect the rated working load limit, and make sure every operator understands how the rigging is meant to be used before the first lift of the day. Small, consistent habits like these tend to matter more over time than any single piece of equipment, no matter how well it is built.

Durability matters as much as initial capacity when choosing rigging equipment, since hardware that wears unevenly or corrodes quickly ends up costing more over its service life. Choosing components built to recognized manufacturing standards is one of the simplest ways to avoid that added cost down the road.

Full specifications are listed below so you can confirm fit against your current rigging before it ships.

Order the Machining & Welding Spreader Beam End Cap Pair to match your existing modular spreader hardware.

Product Info:
•  Style: End Cap Pair
•  Minimum Top Rigging Angle: 45 degrees
•  Shipping Weight: 288 lbs