The Machining & Welding Cantilever Jib Crane 12 FT Span brings rotating, overhead lifting to a single work area without the cost of a full bridge crane. With a 12 foot span and a 2,000 pound working load limit, it covers a circular work zone around its mast.

Mount a hoist or trolley to the boom and the whole assembly rotates, letting one operator load, lift, and swing parts into a machine, workbench, or pallet without repositioning the crane.

A reinforced base plate anchors the mast, while the boom is engineered to carry the working load limit at any point along its span, not just close to the mast.

This is the type of crane most shops add once they notice the same manual lift happening at the same workstation day after day.

Equipment like this shows up across a wide range of industries, from steel fabrication and machine shops to warehousing, construction, and vehicle service centers. Anywhere crews need to move a load overhead in a controlled, repeatable way, a purpose-built lift beam or crane keeps the job safer and faster than improvised rigging. Once a facility standardizes on the right lifting equipment for its typical loads, operators spend less time rigging and more time actually getting work done.

Good lifting practice starts before the load ever leaves the ground: confirm the working load limit fits the job, check that all hardware is in good condition, and keep the load centered to avoid uneven strain on the rigging. These habits matter as much as the equipment itself, and they cost nothing beyond a few extra minutes of attention before each pick, which is a fair trade for a safer shop floor.

Durability matters as much as initial capacity when choosing rigging equipment, since hardware that wears unevenly or corrodes quickly ends up costing more over its service life. Choosing components built to recognized manufacturing standards is one of the simplest ways to avoid that added cost down the road.

The full spec sheet is below, covering capacity, dimensions, and construction details at a glance.

The Machining & Welding Cantilever Jib Crane 12 FT Span is ready to mount a hoist and start handling the same lift, in the same spot, day after day.

Product Info:
•  Working Load Limit: 2,000 lbs
•  Boom Span: 12 ft
•  Style: Cantilever, rotating mast
•  Frame Material: Structural steel
•  Shipping Weight: 1010 lbs