Built as a Style B design, the Machining & Welding 5000 LB Style B Mat Stand carries a 5,000 pound working load limit at 18 inches tall.

Facilities that rotate mats between job sites use stands like this to keep inventory organized and easy to inspect between uses.

The stand is fabricated from structural steel, engineered to hold its rated capacity while supporting mats at a stable working height.

Keeping mats off the ground protects them from moisture and debris that can shorten their service life.

Equipment like this shows up across a wide range of industries, from steel fabrication and machine shops to warehousing, construction, and vehicle service centers. Anywhere crews need to move a load overhead in a controlled, repeatable way, a purpose-built lift beam or crane keeps the job safer and faster than improvised rigging. Once a facility standardizes on the right lifting equipment for its typical loads, operators spend less time rigging and more time actually getting work done.

Good lifting practice starts before the load ever leaves the ground: confirm the working load limit fits the job, check that all hardware is in good condition, and keep the load centered to avoid uneven strain on the rigging. These habits matter as much as the equipment itself, and they cost nothing beyond a few extra minutes of attention before each pick, which is a fair trade for a safer shop floor.

Properly rated hardware, stored and maintained correctly, tends to outlast the equipment it gets paired with. Building a simple habit of checking condition before each use costs very little time and pays off in fewer surprises when a piece of rigging hardware is actually under load.

Details on capacity, dimensions, and hardware are listed below for a quick comparison against your requirements.

The Machining & Welding 5000 LB Style B Mat Stand is ready to keep your mats organized and off the ground.

Product Info:
•  Capacity: 5,000 lbs
•  Style: B
•  Height: 18 in
•  Width: 35.5 in
•  Shipping Weight: 90 lbs