Built as a 10 by 3 foot triangle to triangle assembly, the Machining & Welding Tri-Tri Wire Mesh Sling 10X3 FT carries a 12,000 pound working load limit.

This sling can be rigged as a straight vertical lift or as a choker hitch, giving you two ways to secure a load with the same piece of equipment.

End fittings are rated to match the mesh body, so the complete assembly carries a consistent working load limit from end to end.

The conforming mesh body reduces point-loading on delicate or irregular stock compared to rigid chain or rigid hook connections.

Maintenance departments, fabrication shops, warehouses, and construction crews all rely on equipment in this category to handle lifts that come up again and again. Having the right beam or crane on hand means operators are not left rigging a load with mismatched slings or borrowed hardware, which keeps every lift consistent regardless of who is running it that day.

Good lifting practice starts before the load ever leaves the ground: confirm the working load limit fits the job, check that all hardware is in good condition, and keep the load centered to avoid uneven strain on the rigging. These habits matter as much as the equipment itself, and they cost nothing beyond a few extra minutes of attention before each pick, which is a fair trade for a safer shop floor.

Properly rated hardware, stored and maintained correctly, tends to outlast the equipment it gets paired with. Building a simple habit of checking condition before each use costs very little time and pays off in fewer surprises when a piece of rigging hardware is actually under load.

The full spec sheet is below, covering capacity, dimensions, and construction details at a glance.

Add the Machining & Welding Tri-Tri Wire Mesh Sling 10X3 FT to your sling inventory for heat and abrasion resistant lifting.

Product Info:
•  Working Load Limit: 12,000 lbs
•  Configuration: Triangle to Triangle
•  Width: 10 ft
•  Length: 3 ft
•  Shipping Weight: 28 lbs