The Machining & Welding Tri-Cho Wire Mesh Sling 2X8 FT gives you a ready-to-rig wire mesh sling, 2 feet by 8 feet, rated to 2,300 pounds.

Wire mesh construction wraps and supports irregular or delicate loads, like coils, castings, or rough stock, better than a flat strap or single-point hook.

Steel wire mesh construction resists heat, abrasion, and sharp edges better than synthetic slings, making it a common choice around hot or rough stock.

Wire mesh handles heat and rough surfaces that would cut or melt a synthetic sling, which matters in foundry, forging, and scrap handling work.

Facilities ranging from small machine shops to large distribution centers keep equipment like this on hand for the lifts that come up week after week. It is the kind of tool that earns its spot on the floor by saving time on every single pick, and it pays for itself quickly once it replaces improvised rigging on a recurring job.

Good lifting practice starts before the load ever leaves the ground: confirm the working load limit fits the job, check that all hardware is in good condition, and keep the load centered to avoid uneven strain on the rigging. These habits matter as much as the equipment itself, and they cost nothing beyond a few extra minutes of attention before each pick, which is a fair trade for a safer shop floor.

Well-built rigging hardware holds its rated capacity through years of regular use, provided it is inspected and stored properly between jobs. A dry, organized storage area away from corrosive chemicals or extreme temperature swings goes a long way toward extending the service life of steel components.

Full specifications are listed below so you can confirm fit against your current rigging before it ships.

The Machining & Welding Tri-Cho Wire Mesh Sling 2X8 FT is ready to rig for your next coil, casting, or rough stock lift.

Product Info:
•  Working Load Limit: 2,300 lbs
•  Configuration: Triangle to Choker
•  Width: 2 ft
•  Length: 8 ft
•  Shipping Weight: 12.5 lbs