The Machining & Welding 5 FT - 10 FT Low Hr Adj Length is built for lifts where headroom is tight and load length varies. It adjusts across a 5 to 10 foot range and carries a 10,000 pound working load limit.

This beam is a good fit for maintenance and fabrication work where load sizes change from job to job but hook height above the floor stays limited.

Lifting lugs or shackle points are positioned to keep the rigging geometry efficient across the entire adjustable range of the beam.

In buildings where crane hook travel is already limited, every inch of headroom the beam saves is an inch you get back in usable lift height.

Equipment like this shows up across a wide range of industries, from steel fabrication and machine shops to warehousing, construction, and vehicle service centers. Anywhere crews need to move a load overhead in a controlled, repeatable way, a purpose-built lift beam or crane keeps the job safer and faster than improvised rigging. Once a facility standardizes on the right lifting equipment for its typical loads, operators spend less time rigging and more time actually getting work done.

Pairing the right lifting equipment with proper technique keeps a shop's safety record intact. Inspect connection points regularly, respect the rated working load limit, and make sure every operator understands how the rigging is meant to be used before the first lift of the day. Small, consistent habits like these tend to matter more over time than any single piece of equipment, no matter how well it is built.

Rigging hardware like this sees repeated use, so look for equipment that is properly rated, clearly marked, and traceable to a manufacturer that stands behind its specifications. Keeping documentation on hand for each piece of equipment also makes routine inspections and any future certification requirements easier to manage.

The specifications below cover everything you need to check compatibility with your equipment.

With a quick pin adjustment, the Machining & Welding 5 FT - 10 FT Low Hr Adj Length is set for the next job in less time than it takes to swap a fixed beam.

Product Info:
•  Working Load Limit: 10,000 lbs
•  Adjustable Length Range: 5 ft to 10 ft
•  Profile: Low headroom design
•  Frame Material: Structural steel
•  Shipping Weight: 608 lbs