The Machining & Welding 3/4 IN X 12 IN J-Hook Style A matches 3/4 inch chain size to a 12 inch hook, rated to 1450 pounds.

This style of hook is a common replacement part for chain slings and tie-down assemblies, letting you swap a worn or damaged hook without replacing the whole chain.

Forged from steel and heat treated for strength, the hook is built to standard chain hardware dimensions so it drops into existing assemblies.

Keeping a few of these on hand as spares means a damaged hook does not take an entire chain sling out of service.

From production floors to rail yards to municipal utility crews, this style of equipment gets used wherever a load needs to move safely between two points. Standardizing on purpose-built lifting equipment also makes training new operators easier, since the rigging setup stays consistent from lift to lift instead of changing based on whatever hardware happens to be nearby.

Rated capacity should always be treated as a hard limit, not a target, and a quick visual inspection before each lift is one of the simplest ways to keep a lifting operation safe. Make sure your operators are trained on the specific rigging setup this equipment requires, and confirm that anyone signing off on a lift understands how to read the working load limit and match it against the actual load being moved.

Equipment that sees daily use benefits from a quick visual check every time it comes out of storage, not just during scheduled inspections. Catching a small issue, like surface corrosion or a bent component, before it becomes a larger problem keeps rigging hardware safe and in service longer.

Details on capacity, dimensions, and hardware are listed below for a quick comparison against your requirements.

The Machining & Welding 3/4 IN X 12 IN J-Hook Style A is ready to go into service as a replacement or spare for 3/4 inch chain rigging.

Product Info:
•  Capacity: 1450 lbs
•  Rod Diameter: 3/4 in
•  Hook Length: 12 in
•  Style: Style A
•  Shipping Weight: 2.5 lbs