Built for 1/4 inch chain, the Machining & Welding 1/4 IN X 12 IN J-Hook Style A carries a 100 pound rating with a 12 inch hook length.

This style of hook is a common replacement part for chain slings and tie-down assemblies, letting you swap a worn or damaged hook without replacing the whole chain.

The hook is manufactured to match standard chain grade and size specifications, keeping the rated capacity consistent with the chain it is paired with.

Keeping a few of these on hand as spares means a damaged hook does not take an entire chain sling out of service.

Maintenance departments, fabrication shops, warehouses, and construction crews all rely on equipment in this category to handle lifts that come up again and again. Having the right beam or crane on hand means operators are not left rigging a load with mismatched slings or borrowed hardware, which keeps every lift consistent regardless of who is running it that day.

Pairing the right lifting equipment with proper technique keeps a shop's safety record intact. Inspect connection points regularly, respect the rated working load limit, and make sure every operator understands how the rigging is meant to be used before the first lift of the day. Small, consistent habits like these tend to matter more over time than any single piece of equipment, no matter how well it is built.

Properly rated hardware, stored and maintained correctly, tends to outlast the equipment it gets paired with. Building a simple habit of checking condition before each use costs very little time and pays off in fewer surprises when a piece of rigging hardware is actually under load.

Full specifications are listed below so you can confirm fit against your current rigging before it ships.

The Machining & Welding 1/4 IN X 12 IN J-Hook Style A is ready to go into service as a replacement or spare for 1/4 inch chain rigging.

Product Info:
•  Capacity: 100 lbs
•  Rod Diameter: 1/4 in
•  Hook Length: 12 in
•  Style: Style A
•  Shipping Weight: 1 lbs