The Machining & Welding 3/4 IN Wire Rope Ferrule is a swage ferrule sized for 3/4 inch wire rope, built from stainless steel.

This sleeve is swaged with a hydraulic press to permanently secure a wire rope loop, eliminating the need for clips or knots at the termination point.

Material choice between carbon and stainless steel lets you match the ferrule to the wire rope's own material and the assembly's environment.

A properly swaged ferrule can achieve close to the full breaking strength of the wire rope, which loose clips generally cannot match.

Maintenance departments, fabrication shops, warehouses, and construction crews all rely on equipment in this category to handle lifts that come up again and again. Having the right beam or crane on hand means operators are not left rigging a load with mismatched slings or borrowed hardware, which keeps every lift consistent regardless of who is running it that day.

Good lifting practice starts before the load ever leaves the ground: confirm the working load limit fits the job, check that all hardware is in good condition, and keep the load centered to avoid uneven strain on the rigging. These habits matter as much as the equipment itself, and they cost nothing beyond a few extra minutes of attention before each pick, which is a fair trade for a safer shop floor.

Rigging hardware like this sees repeated use, so look for equipment that is properly rated, clearly marked, and traceable to a manufacturer that stands behind its specifications. Keeping documentation on hand for each piece of equipment also makes routine inspections and any future certification requirements easier to manage.

The specifications below cover everything you need to check compatibility with your equipment.

The Machining & Welding 3/4 IN Wire Rope Ferrule is ready to swage onto your next wire rope assembly.

Product Info:
•  Wire Rope Diameter: 3/4 in
•  Ferrule Outer Diameter: 1.5 in
•  Ferrule Length: 3.25 in
•  Material: Stainless steel
•  Shipping Weight: 1.35 lbs