Built from 2 inch wire rope, the Machining & Welding 2 IN 2-Leg Wr Bridle gives you a 2-leg bridle for multi-point lifts.

Multi-leg bridles like this connect to lift points on a load and gather at a single master link, letting a crane or hoist pick the load from multiple points at once.

Each leg is fabricated from wire rope with swaged or mechanically spliced end fittings, gathered at a master link rated to match the assembly.

For heavy structural and equipment rigging, wire rope holds up to repeated use and rough handling better than many alternatives.

This type of lifting equipment is common in facilities that move machinery, structural steel, crates, or bulky components as part of daily operations. Rather than treating each lift as a one-off problem, a dedicated piece of equipment turns it into a routine, repeatable task that any trained operator can complete quickly and safely.

Good lifting practice starts before the load ever leaves the ground: confirm the working load limit fits the job, check that all hardware is in good condition, and keep the load centered to avoid uneven strain on the rigging. These habits matter as much as the equipment itself, and they cost nothing beyond a few extra minutes of attention before each pick, which is a fair trade for a safer shop floor.

Equipment that sees daily use benefits from a quick visual check every time it comes out of storage, not just during scheduled inspections. Catching a small issue, like surface corrosion or a bent component, before it becomes a larger problem keeps rigging hardware safe and in service longer.

The full spec sheet is below, covering capacity, dimensions, and construction details at a glance.

Order the Machining & Welding 2 IN 2-Leg Wr Bridle for a 2-leg bridle built from 2 inch wire rope.

Product Info:
•  Working Load Limit: 104,000 lbs
•  Wire Rope Diameter: 2 in
•  Legs: 2
•  Connection: 104,000 LB WLL AT 45 DEG
•  Shipping Weight: See product tag