The Machining & Welding 10000 LB 25 FT Fixed Spreader Beam spreads your rigging across 25 feet, rated to 10,000 pounds.

This beam suits loads that are wider than a single sling point can safely support, spreading the rigging to keep the load level and the sling angles closer to vertical.

Steel construction throughout keeps deflection low under load, and the swivel connections allow the rigging to settle naturally as the load lifts.

For loads that always fall within a known width range, a fixed spreader beam is a simple, dependable choice.

This type of lifting equipment is common in facilities that move machinery, structural steel, crates, or bulky components as part of daily operations. Rather than treating each lift as a one-off problem, a dedicated piece of equipment turns it into a routine, repeatable task that any trained operator can complete quickly and safely.

Good lifting practice starts before the load ever leaves the ground: confirm the working load limit fits the job, check that all hardware is in good condition, and keep the load centered to avoid uneven strain on the rigging. These habits matter as much as the equipment itself, and they cost nothing beyond a few extra minutes of attention before each pick, which is a fair trade for a safer shop floor.

Properly rated hardware, stored and maintained correctly, tends to outlast the equipment it gets paired with. Building a simple habit of checking condition before each use costs very little time and pays off in fewer surprises when a piece of rigging hardware is actually under load.

The full spec sheet is below, covering capacity, dimensions, and construction details at a glance.

The Machining & Welding 10000 LB 25 FT Fixed Spreader Beam is ready to spread your rigging and keep the next lift level.

Product Info:
•  Working Load Limit: 10,000 lbs
•  Beam Length: 25 ft
•  Connection: SWIVEL HOOK CONNECTIONS
•  Frame Material: Structural steel
•  Shipping Weight: 578 lbs