Built to keep cost down without cutting corners on capacity, the Machining & Welding 1000 LB 96 IN Economy Lift Beam offers 96 inches of beam length rated to 1,000 pounds.

This beam suits crates, panels, motors, and general shop loads where a simple two-point pick is all the job requires.

The beam is fabricated from structural steel in a compact, low profile cross-section that keeps both weight and headroom to a minimum.

Keeping a dedicated beam on hand for common loads saves time compared to reconfiguring an adjustable beam for the same job every day.

Maintenance departments, fabrication shops, warehouses, and construction crews all rely on equipment in this category to handle lifts that come up again and again. Having the right beam or crane on hand means operators are not left rigging a load with mismatched slings or borrowed hardware, which keeps every lift consistent regardless of who is running it that day.

Good lifting practice starts before the load ever leaves the ground: confirm the working load limit fits the job, check that all hardware is in good condition, and keep the load centered to avoid uneven strain on the rigging. These habits matter as much as the equipment itself, and they cost nothing beyond a few extra minutes of attention before each pick, which is a fair trade for a safer shop floor.

Properly rated hardware, stored and maintained correctly, tends to outlast the equipment it gets paired with. Building a simple habit of checking condition before each use costs very little time and pays off in fewer surprises when a piece of rigging hardware is actually under load.

Details on capacity, dimensions, and hardware are listed below for a quick comparison against your requirements.

Add the Machining & Welding 1000 LB 96 IN Economy Lift Beam to your rack for the low headroom picks that come up more often than you would expect.

Product Info:
•  Working Load Limit: 1,000 lbs
•  Beam Length: 96 in
•  Headroom: 10.25 in
•  Frame Material: Structural steel
•  Shipping Weight: 63 lbs