The Machining & Welding 1 IN Wire Rope Thr Stud is a threaded terminal fitting sized for 1 inch wire rope, built from stainless steel.

This fitting is swaged onto the rope end during assembly, creating a permanent, rated termination that accepts standard threaded hardware on the other end.

Consistent thread dimensions and swage geometry keep this fitting compatible with standard wire rope assembly equipment and mating hardware.

Choosing the correct material and wire rope diameter matters, since a mismatched fitting will not swage correctly even if the general size looks close.

This type of lifting equipment is common in facilities that move machinery, structural steel, crates, or bulky components as part of daily operations. Rather than treating each lift as a one-off problem, a dedicated piece of equipment turns it into a routine, repeatable task that any trained operator can complete quickly and safely.

Before putting any lifting equipment into service, verify it matches your hoist or crane setup and confirm the rated capacity covers your heaviest expected load with margin to spare. Routine inspection of welds, pins, and connection hardware helps catch wear before it becomes a safety issue. Keep a simple inspection log if your facility does not already have one, since tracking wear over time makes it easier to plan replacement before a part actually fails in use.

Properly rated hardware, stored and maintained correctly, tends to outlast the equipment it gets paired with. Building a simple habit of checking condition before each use costs very little time and pays off in fewer surprises when a piece of rigging hardware is actually under load.

The specifications below cover everything you need to check compatibility with your equipment.

The Machining & Welding 1 IN Wire Rope Thr Stud is ready to terminate your wire rope with a threaded connection.

Product Info:
•  Wire Rope Diameter: 1 in
•  Material: Stainless steel
•  Shipping Weight: 12.6 lbs