The Machining & Welding 1 IN Wire Rope Thr Stud is a threaded terminal fitting sized for 1 inch wire rope, built from carbon steel.

Wire rope assemblies use threaded studs at one or both ends when the application calls for a bolted or threaded connection rather than a hook or loop.

Consistent thread dimensions and swage geometry keep this fitting compatible with standard wire rope assembly equipment and mating hardware.

Choosing the correct material and wire rope diameter matters, since a mismatched fitting will not swage correctly even if the general size looks close.

This type of lifting equipment is common in facilities that move machinery, structural steel, crates, or bulky components as part of daily operations. Rather than treating each lift as a one-off problem, a dedicated piece of equipment turns it into a routine, repeatable task that any trained operator can complete quickly and safely.

Good lifting practice starts before the load ever leaves the ground: confirm the working load limit fits the job, check that all hardware is in good condition, and keep the load centered to avoid uneven strain on the rigging. These habits matter as much as the equipment itself, and they cost nothing beyond a few extra minutes of attention before each pick, which is a fair trade for a safer shop floor.

Durability matters as much as initial capacity when choosing rigging equipment, since hardware that wears unevenly or corrodes quickly ends up costing more over its service life. Choosing components built to recognized manufacturing standards is one of the simplest ways to avoid that added cost down the road.

Details on capacity, dimensions, and hardware are listed below for a quick comparison against your requirements.

Order the Machining & Welding 1 IN Wire Rope Thr Stud sized to match your wire rope and mating hardware.

Product Info:
•  Wire Rope Diameter: 1 in
•  Material: Carbon steel
•  Shipping Weight: 12.6 lbs