The Machining & Welding 1 IN Wire Rope Ferrule is a swage ferrule sized for 1 inch wire rope, built from carbon steel.

This sleeve is swaged with a hydraulic press to permanently secure a wire rope loop, eliminating the need for clips or knots at the termination point.

Material choice between carbon and stainless steel lets you match the ferrule to the wire rope's own material and the assembly's environment.

A properly swaged ferrule can achieve close to the full breaking strength of the wire rope, which loose clips generally cannot match.

From production floors to rail yards to municipal utility crews, this style of equipment gets used wherever a load needs to move safely between two points. Standardizing on purpose-built lifting equipment also makes training new operators easier, since the rigging setup stays consistent from lift to lift instead of changing based on whatever hardware happens to be nearby.

Good lifting practice starts before the load ever leaves the ground: confirm the working load limit fits the job, check that all hardware is in good condition, and keep the load centered to avoid uneven strain on the rigging. These habits matter as much as the equipment itself, and they cost nothing beyond a few extra minutes of attention before each pick, which is a fair trade for a safer shop floor.

Equipment that sees daily use benefits from a quick visual check every time it comes out of storage, not just during scheduled inspections. Catching a small issue, like surface corrosion or a bent component, before it becomes a larger problem keeps rigging hardware safe and in service longer.

The specifications below cover everything you need to check compatibility with your equipment.

Add the Machining & Welding 1 IN Wire Rope Ferrule to your wire rope termination supplies.

Product Info:
•  Wire Rope Diameter: 1 in
•  Ferrule Outer Diameter: 2 in
•  Ferrule Length: 4.75 in
•  Material: Carbon steel
•  Shipping Weight: 3.53 lbs