The Machining & Welding 1 IN Wire Rope Ferrule is a swage ferrule sized for 1 inch wire rope, built from carbon steel.

This sleeve is swaged with a hydraulic press to permanently secure a wire rope loop, eliminating the need for clips or knots at the termination point.

Material choice between carbon and stainless steel lets you match the ferrule to the wire rope's own material and the assembly's environment.

Keeping the right size ferrule on hand for each wire rope diameter you work with speeds up assembly and repair work in house.

From production floors to rail yards to municipal utility crews, this style of equipment gets used wherever a load needs to move safely between two points. Standardizing on purpose-built lifting equipment also makes training new operators easier, since the rigging setup stays consistent from lift to lift instead of changing based on whatever hardware happens to be nearby.

Good lifting practice starts before the load ever leaves the ground: confirm the working load limit fits the job, check that all hardware is in good condition, and keep the load centered to avoid uneven strain on the rigging. These habits matter as much as the equipment itself, and they cost nothing beyond a few extra minutes of attention before each pick, which is a fair trade for a safer shop floor.

Properly rated hardware, stored and maintained correctly, tends to outlast the equipment it gets paired with. Building a simple habit of checking condition before each use costs very little time and pays off in fewer surprises when a piece of rigging hardware is actually under load.

Details on capacity, dimensions, and hardware are listed below for a quick comparison against your requirements.

The Machining & Welding 1 IN Wire Rope Ferrule is ready to swage onto your next wire rope assembly.

Product Info:
•  Wire Rope Diameter: 1 in
•  Ferrule Outer Diameter: 2 in
•  Ferrule Length: 4.36 in
•  Material: Carbon steel
•  Shipping Weight: 3.23 lbs