The Machining & Welding 1-3/8 IN Wire Rope Thr Stud is a threaded terminal fitting sized for 1-3/8 inch wire rope, swaged onto a 8.25 inch stud with 2-3/4 inch fine thread and a right-hand thread direction.

Wire rope assemblies use threaded studs at one or both ends when the application calls for a bolted or threaded connection rather than a hook or loop.

Consistent thread dimensions and swage geometry keep this fitting compatible with standard wire rope assembly equipment and mating hardware.

Getting the thread size, pitch, and hand correct matters, since a mismatched stud will not thread into its mating hardware even if the wire rope size is right.

Equipment like this shows up across a wide range of industries, from steel fabrication and machine shops to warehousing, construction, and vehicle service centers. Anywhere crews need to move a load overhead in a controlled, repeatable way, a purpose-built lift beam or crane keeps the job safer and faster than improvised rigging. Once a facility standardizes on the right lifting equipment for its typical loads, operators spend less time rigging and more time actually getting work done.

As with any lifting equipment, never exceed the rated working load limit, and inspect slings, hooks, shackles, and connection points before every use. Confirm compatibility with your hoist, crane, or trolley system before placing an order, and follow your facility's rigging and lockout procedures for every lift. A few minutes spent checking hardware condition and load balance up front is far cheaper than dealing with a dropped or shifted load later, and it keeps your team's daily routine consistent from one job to the next.

Durability matters as much as initial capacity when choosing rigging equipment, since hardware that wears unevenly or corrodes quickly ends up costing more over its service life. Choosing components built to recognized manufacturing standards is one of the simplest ways to avoid that added cost down the road.

See the specifications below for the exact numbers you will want to check before ordering.

The Machining & Welding 1-3/8 IN Wire Rope Thr Stud is ready to terminate your wire rope with a threaded connection.

Product Info:
•  Wire Rope Diameter: 1-3/8 in
•  Stud Length: 8.25 in
•  Thread Size: 2-3/4 in
•  Thread Pitch: Fine
•  Thread Hand: Right-hand
•  Shipping Weight: 30.5 lbs