The Machining & Welding 1-1/2 IN Wire Rope Thr Stud is a threaded terminal fitting sized for 1-1/2 inch wire rope, built from carbon steel.

Threaded studs like this terminate a wire rope end with a machine thread instead of a hook or eye, letting you thread the assembly directly into a fitting, turnbuckle, or clevis.

Manufactured to consistent tolerances, the fitting swages onto the wire rope with a rated holding strength that matches the rope it is paired with.

Matching carbon or stainless construction to your wire rope and its environment helps the fitting hold up as long as the rope itself.

This type of lifting equipment is common in facilities that move machinery, structural steel, crates, or bulky components as part of daily operations. Rather than treating each lift as a one-off problem, a dedicated piece of equipment turns it into a routine, repeatable task that any trained operator can complete quickly and safely.

Good lifting practice starts before the load ever leaves the ground: confirm the working load limit fits the job, check that all hardware is in good condition, and keep the load centered to avoid uneven strain on the rigging. These habits matter as much as the equipment itself, and they cost nothing beyond a few extra minutes of attention before each pick, which is a fair trade for a safer shop floor.

Properly rated hardware, stored and maintained correctly, tends to outlast the equipment it gets paired with. Building a simple habit of checking condition before each use costs very little time and pays off in fewer surprises when a piece of rigging hardware is actually under load.

The full spec sheet is below, covering capacity, dimensions, and construction details at a glance.

Add the Machining & Welding 1-1/2 IN Wire Rope Thr Stud to your wire rope assembly parts inventory.

Product Info:
•  Wire Rope Diameter: 1-1/2 in
•  Material: Carbon steel
•  Shipping Weight: 41.1 lbs