The Machining & Welding 1-1/2 IN Wire Rope Thr Stud is a threaded terminal fitting sized for 1-1/2 inch wire rope, built from carbon steel.

Threaded studs like this terminate a wire rope end with a machine thread instead of a hook or eye, letting you thread the assembly directly into a fitting, turnbuckle, or clevis.

Manufactured to consistent tolerances, the fitting swages onto the wire rope with a rated holding strength that matches the rope it is paired with.

Choosing the correct material and wire rope diameter matters, since a mismatched fitting will not swage correctly even if the general size looks close.

Equipment like this shows up across a wide range of industries, from steel fabrication and machine shops to warehousing, construction, and vehicle service centers. Anywhere crews need to move a load overhead in a controlled, repeatable way, a purpose-built lift beam or crane keeps the job safer and faster than improvised rigging. Once a facility standardizes on the right lifting equipment for its typical loads, operators spend less time rigging and more time actually getting work done.

Good lifting practice starts before the load ever leaves the ground: confirm the working load limit fits the job, check that all hardware is in good condition, and keep the load centered to avoid uneven strain on the rigging. These habits matter as much as the equipment itself, and they cost nothing beyond a few extra minutes of attention before each pick, which is a fair trade for a safer shop floor.

Properly rated hardware, stored and maintained correctly, tends to outlast the equipment it gets paired with. Building a simple habit of checking condition before each use costs very little time and pays off in fewer surprises when a piece of rigging hardware is actually under load.

Full specifications are listed below so you can confirm fit against your current rigging before it ships.

The Machining & Welding 1-1/2 IN Wire Rope Thr Stud is ready to terminate your wire rope with a threaded connection.

Product Info:
•  Wire Rope Diameter: 1-1/2 in
•  Material: Carbon steel
•  Shipping Weight: 41.1 lbs