Cable Shield Pin “ SKU: 661 The Pivot Pin That Anchors Your Cable Shield Assembly on the Lug-All 6000-15 In any mechanical assembly, the fastening hardware is only as reliable as its weakest component ” and the cable shield pin is the single fastener that holds the cable shield assembly in its operating position on the main frame. The Cable Shield Pin (SKU: 661) is the genuine OEM replacement pivot pin engineered exclusively for the Lug-All model 6000-15, securing the cable shield assembly at its pivot point so it functions correctly on every lift and lower. This cable shield pin is compatible with Lug-All model 6000-15 only. Lug-All The Lug-All model 6000-15 is a heavy-duty, industrial-grade 3-ton cable come along hoist ” delivering 3,000 lbs with 15 feet of 5/16-inch 7×19 aircraft cable in single line, or 6,000 lbs with 7 feet 6 inches of cable in double line. ShoreLandr Per the official 6000-15SH parts list, the cable shield pin (Part #661) is the second of three components that make up the complete cable shield sub-assembly ” the cable shield assembly (Part #660) is pivoted onto the main frame by this pin, and then retained in position by the cable shield retaining ring (Part #696). The pin passes through aligned bores in both the cable shield assembly and the main frame, creating the pivot axis that allows the shield to be opened for cable servicing and repositioned closed for operation. The retaining ring at the pin's end keeps it from backing out under vibration and repeated load cycles. J Harlen Co. Without an intact, correctly dimensioned cable shield pin, the shield assembly cannot be properly anchored to the main frame. A bent, corroded, or undersized substitute pin creates play in the pivot ” allowing the shield to shift out of alignment with the drum and cable entry point, defeating its purpose of protecting the 5/16-inch cable from contact with the ratchet teeth, drum housing, and frame castings. The 6000-15 uses a 7×19 highly flexible self-storing aircraft cable, and the cable shield system ensures that cable stores cleanly and exits the drum cleanly on every cycle ” a performance standard that depends on every component of the cable shield sub-assembly, including this pin, being genuine OEM specification. Rigging Warehouse Using authentic Lug-All replacement parts means sustaining the original design integrity of your unit ” the cast-aluminum structure, robust pawl assemblies, and reliable hardware that make Lug-All hoists a trusted choice in demanding industrial, construction, and utility settings. Lug-All

Product Specifications SpecificationDetailSKU / Part Number661Part NameCable Shield PinCompatible ModelLug-All #6000-15 onlyHoist Type3-Ton Cable Ratchet Winch HoistHoist Capacity (Single Line)3,000 lbsHoist Capacity (Double Line)6,000 lbsCable Diameter5/16" (7×19 aircraft cable)Used WithCable Shield Assembly #660, Cable Shield Retaining Ring #696Component CategoryCable Shield Sub-Assembly / Pivot HardwareCountry of OriginUSA

Installation Note The SKU 661 cable shield pin is a 6000-15-specific component ” distinct from the cable shield pin (Part #161) used on all other Lug-All cable hoist models. When replacing the cable shield pin, always inspect the retaining ring (SKU: 696) at the same time and replace it if worn, distorted, or removed. Never reinstall a previously compressed retaining ring. Order SKU 661 today and keep your Lug-All 6000-15 cable shield assembly properly pivoted and locked in place.