Pulley Wheel “ SKU: 685 The Load-Bearing Sheave That Redirects Your Cable in Double-Line Configuration When you configure your Lug-All 6000-15 for double-line operation, the pulley wheel is where the cable makes its critical direction change ” redirecting from the hoist drum, around the sheave, and back to the load anchor point, effectively doubling the mechanical advantage to 6,000 lbs of lifting or pulling force. The Pulley Wheel (SKU: 685) is the genuine OEM replacement pulley with bushing for the Lug-All model 6000-15's pulley block assembly. Per the official 6000-15SH parts list, Part #685 is listed as "Pulley W/Bushing" at reference position #38 in the pulley block sub-assembly ” confirming that the SKU 685 includes the integrated bushing as a single assembled unit, not just the sheave wheel casting alone. Lug-All The Lug-All model 6000-15 is a heavy-duty, industrial-grade 3-ton cable come along hoist ” delivering 3,000 lbs in single line with 15 feet of cable, or 6,000 lbs in double line with 7 feet 6 inches of cable. Lug-All The pulley wheel rotates on the pulley shaft (Part #686) within the yoke casting (Part #684), with the integrated bushing providing the low-friction bearing interface between the rotating wheel and the stationary shaft. In wire rope pulley blocks, the bushing type directly affects wear life and maintenance requirements ” oiled bushings provide a self-lubricating bearing surface that distributes shaft load over a wider contact area, reducing point wear on both the shaft and the bore during repeated high-load cycling. Lug-All At 6,000 lbs of double-line load, the cable tension against the sheave groove produces a compressive force on the pulley shaft that the bushing must transmit smoothly into the yoke. A worn or seized bushing that no longer rotates freely forces the cable to drag across the sheave groove rather than roll freely over it ” causing accelerated cable wear, heat generation, and significantly increased handle pulling force requirements for any given load. Additionally, the sheave groove profile must match the cable diameter precisely. The SKU 685 Pulley W/Bushing is specifically sized for the 5/16-inch aircraft cable used on the 6000-15 ” a sheave from any other Lug-All model with a different cable diameter will not provide the correct groove support for the 6000-15's cable, leading to premature strand fatigue and potential cable failure under load. Lug-All Using authentic Lug-All replacement parts means sustaining the original design integrity of your unit ” the cast-aluminum structure, robust pawl assemblies, and reliable hardware that make Lug-All hoists a trusted choice in demanding industrial, construction, and utility settings. Lug-All

Product Specifications SpecificationDetailSKU / Part Number685Part NamePulley Wheel (Pulley W/Bushing)Compatible ModelLug-All #6000-15 onlyParts List ReferencePosition #38 (6000-15SH parts list)AssemblyPulley + Integrated BushingHoist Type3-Ton Cable Ratchet Winch HoistHoist Capacity (Double Line)6,000 lbsCable Diameter5/16" (7×19 aircraft cable)Works WithPulley Shaft #686, Yoke #684, Shaft Locking Pin #687Component CategoryPulley Block / Double-Line SheaveCountry of OriginUSA

Service Recommendation When replacing the pulley wheel, always inspect the pulley shaft (SKU: 686) for wear grooves and the shaft locking pin (SKU: 687) for deformation. Replace as a set for best service life. For the complete pulley block assembly, see the Pulley Block Assembly for the 6000-15. Order SKU 685 today and keep your Lug-All 6000-15 pulley block operating at full 6,000-lb double-line capacity.