The Machining & Welding 9/16 IN Wire Rope Thr Stud is a threaded terminal fitting sized for 9/16 inch wire rope, built from carbon steel.

This fitting is swaged onto the rope end during assembly, creating a permanent, rated termination that accepts standard threaded hardware on the other end.

Consistent thread dimensions and swage geometry keep this fitting compatible with standard wire rope assembly equipment and mating hardware.

Choosing the correct material and wire rope diameter matters, since a mismatched fitting will not swage correctly even if the general size looks close.

This type of lifting equipment is common in facilities that move machinery, structural steel, crates, or bulky components as part of daily operations. Rather than treating each lift as a one-off problem, a dedicated piece of equipment turns it into a routine, repeatable task that any trained operator can complete quickly and safely.

Good lifting practice starts before the load ever leaves the ground: confirm the working load limit fits the job, check that all hardware is in good condition, and keep the load centered to avoid uneven strain on the rigging. These habits matter as much as the equipment itself, and they cost nothing beyond a few extra minutes of attention before each pick, which is a fair trade for a safer shop floor.

Properly rated hardware, stored and maintained correctly, tends to outlast the equipment it gets paired with. Building a simple habit of checking condition before each use costs very little time and pays off in fewer surprises when a piece of rigging hardware is actually under load.

Full specifications are listed below so you can confirm fit against your current rigging before it ships.

The Machining & Welding 9/16 IN Wire Rope Thr Stud is ready to terminate your wire rope with a threaded connection.

Product Info:
•  Wire Rope Diameter: 9/16 in
•  Material: Carbon steel
•  Shipping Weight: 2.33 lbs