The Machining & Welding 7/8 IN Wire Rope Thr Stud is a threaded terminal fitting sized for 7/8 inch wire rope, built from carbon steel.

This fitting is swaged onto the rope end during assembly, creating a permanent, rated termination that accepts standard threaded hardware on the other end.

Manufactured to consistent tolerances, the fitting swages onto the wire rope with a rated holding strength that matches the rope it is paired with.

These are precision components, and ordering the exact size and specification avoids a costly reswage if the fitting does not match your hardware.

Maintenance departments, fabrication shops, warehouses, and construction crews all rely on equipment in this category to handle lifts that come up again and again. Having the right beam or crane on hand means operators are not left rigging a load with mismatched slings or borrowed hardware, which keeps every lift consistent regardless of who is running it that day.

Before putting any lifting equipment into service, verify it matches your hoist or crane setup and confirm the rated capacity covers your heaviest expected load with margin to spare. Routine inspection of welds, pins, and connection hardware helps catch wear before it becomes a safety issue. Keep a simple inspection log if your facility does not already have one, since tracking wear over time makes it easier to plan replacement before a part actually fails in use.

Properly rated hardware, stored and maintained correctly, tends to outlast the equipment it gets paired with. Building a simple habit of checking condition before each use costs very little time and pays off in fewer surprises when a piece of rigging hardware is actually under load.

The full spec sheet is below, covering capacity, dimensions, and construction details at a glance.

The Machining & Welding 7/8 IN Wire Rope Thr Stud is ready to terminate your wire rope with a threaded connection.

Product Info:
•  Wire Rope Diameter: 7/8 in
•  Material: Carbon steel
•  Shipping Weight: 8.58 lbs