The Machining & Welding 6000 LB Non-Conductive Lift Beam is built for lifts near live electrical equipment, rated to 6,000 pounds and adjustable from 42 to 54 inches.

Utility crews and electrical contractors use non-conductive rigging like this to add a layer of protection during lifts around energized equipment.

The adjustable frame is engineered from non-conductive material rated to carry its full working load limit at any length within range.

Electrical safety around energized equipment is not optional, and non-conductive rigging is one layer of protection crews rely on.

Facilities ranging from small machine shops to large distribution centers keep equipment like this on hand for the lifts that come up week after week. It is the kind of tool that earns its spot on the floor by saving time on every single pick, and it pays for itself quickly once it replaces improvised rigging on a recurring job.

Before putting any lifting equipment into service, verify it matches your hoist or crane setup and confirm the rated capacity covers your heaviest expected load with margin to spare. Routine inspection of welds, pins, and connection hardware helps catch wear before it becomes a safety issue. Keep a simple inspection log if your facility does not already have one, since tracking wear over time makes it easier to plan replacement before a part actually fails in use.

Properly rated hardware, stored and maintained correctly, tends to outlast the equipment it gets paired with. Building a simple habit of checking condition before each use costs very little time and pays off in fewer surprises when a piece of rigging hardware is actually under load.

The full spec sheet is below, covering capacity, dimensions, and construction details at a glance.

The Machining & Welding 6000 LB Non-Conductive Lift Beam is ready for lifts where electrical safety is part of the job.

Product Info:
•  Working Load Limit: 6,000 lbs
•  Adjustable Range: 42 in to 54 in
•  Frame Material: Non-conductive composite
•  Shipping Weight: 150 lbs