Built from stainless steel, the Machining & Welding 5/8 IN Wire Rope Ferrule swages onto 5/8 inch wire rope to form a rated eye or splice.

This sleeve is swaged with a hydraulic press to permanently secure a wire rope loop, eliminating the need for clips or knots at the termination point.

Consistent wall thickness and bore diameter keep the swage strength predictable from one ferrule to the next.

A properly swaged ferrule can achieve close to the full breaking strength of the wire rope, which loose clips generally cannot match.

This type of lifting equipment is common in facilities that move machinery, structural steel, crates, or bulky components as part of daily operations. Rather than treating each lift as a one-off problem, a dedicated piece of equipment turns it into a routine, repeatable task that any trained operator can complete quickly and safely.

Good lifting practice starts before the load ever leaves the ground: confirm the working load limit fits the job, check that all hardware is in good condition, and keep the load centered to avoid uneven strain on the rigging. These habits matter as much as the equipment itself, and they cost nothing beyond a few extra minutes of attention before each pick, which is a fair trade for a safer shop floor.

Equipment that sees daily use benefits from a quick visual check every time it comes out of storage, not just during scheduled inspections. Catching a small issue, like surface corrosion or a bent component, before it becomes a larger problem keeps rigging hardware safe and in service longer.

See the specifications below for the exact numbers you will want to check before ordering.

Order the Machining & Welding 5/8 IN Wire Rope Ferrule sized to match your wire rope diameter and material.

Product Info:
•  Wire Rope Diameter: 5/8 in
•  Ferrule Outer Diameter: 1.375 in
•  Ferrule Length: 2.5 in
•  Material: Stainless steel
•  Shipping Weight: 0.93 lbs