The Machining & Welding 500 LB 54 IN Economy Lift Beam is sized at 54 inches with a 500 pound rating, an economical option for routine two-point lifts.

This beam suits crates, panels, motors, and general shop loads where a simple two-point pick is all the job requires.

The beam's low headroom profile is built into the steel cross-section itself, not added on, keeping the unit compact and durable.

Low headroom design recovers usable hook travel in shops where ceiling clearance is already limited.

Facilities ranging from small machine shops to large distribution centers keep equipment like this on hand for the lifts that come up week after week. It is the kind of tool that earns its spot on the floor by saving time on every single pick, and it pays for itself quickly once it replaces improvised rigging on a recurring job.

Pairing the right lifting equipment with proper technique keeps a shop's safety record intact. Inspect connection points regularly, respect the rated working load limit, and make sure every operator understands how the rigging is meant to be used before the first lift of the day. Small, consistent habits like these tend to matter more over time than any single piece of equipment, no matter how well it is built.

Durability matters as much as initial capacity when choosing rigging equipment, since hardware that wears unevenly or corrodes quickly ends up costing more over its service life. Choosing components built to recognized manufacturing standards is one of the simplest ways to avoid that added cost down the road.

Details on capacity, dimensions, and hardware are listed below for a quick comparison against your requirements.

The Machining & Welding 500 LB 54 IN Economy Lift Beam is ready for the routine lifts that make up most of a typical shop day.

Product Info:
•  Working Load Limit: 500 lbs
•  Beam Length: 54 in
•  Headroom: 10.25 in
•  Frame Material: Structural steel
•  Shipping Weight: 30 lbs