Rated to 4,900 pounds and sold in pairs, the Machining & Welding 4900 LB Load Hooks is built for load handling.

This style of hook is common for lifting long, rigid loads like pipe or beams that need support at two points to stay level during the lift.

Each hook is forged from steel, engineered to hold half the assembly's total rated capacity so the pair together carries the full rating.

Two-point picks keep long or rigid loads level in a way a single hook cannot, which matters for pipe, beams, and similar stock.

From production floors to rail yards to municipal utility crews, this style of equipment gets used wherever a load needs to move safely between two points. Standardizing on purpose-built lifting equipment also makes training new operators easier, since the rigging setup stays consistent from lift to lift instead of changing based on whatever hardware happens to be nearby.

Good lifting practice starts before the load ever leaves the ground: confirm the working load limit fits the job, check that all hardware is in good condition, and keep the load centered to avoid uneven strain on the rigging. These habits matter as much as the equipment itself, and they cost nothing beyond a few extra minutes of attention before each pick, which is a fair trade for a safer shop floor.

Rigging hardware like this sees repeated use, so look for equipment that is properly rated, clearly marked, and traceable to a manufacturer that stands behind its specifications. Keeping documentation on hand for each piece of equipment also makes routine inspections and any future certification requirements easier to manage.

Full specifications are listed below so you can confirm fit against your current rigging before it ships.

The Machining & Welding 4900 LB Load Hooks is ready to support your next two-point pick.

Product Info:
•  Capacity: 4,900 lbs
•  Type: Load
•  Sold As: Pair, rated as pair
•  Shipping Weight: 4 lbs