Built for consistent, repeatable lifts, the Machining & Welding 40000 LB 6 FT Fixed Spreader Beam spans 6 feet at a 40,000 pound working load limit.

This beam suits loads that are wider than a single sling point can safely support, spreading the rigging to keep the load level and the sling angles closer to vertical.

As a fixed length design, there is no adjustment mechanism to inspect, just a solid steel beam ready to rig.

For loads that always fall within a known width range, a fixed spreader beam is a simple, dependable choice.

This type of lifting equipment is common in facilities that move machinery, structural steel, crates, or bulky components as part of daily operations. Rather than treating each lift as a one-off problem, a dedicated piece of equipment turns it into a routine, repeatable task that any trained operator can complete quickly and safely.

Good lifting practice starts before the load ever leaves the ground: confirm the working load limit fits the job, check that all hardware is in good condition, and keep the load centered to avoid uneven strain on the rigging. These habits matter as much as the equipment itself, and they cost nothing beyond a few extra minutes of attention before each pick, which is a fair trade for a safer shop floor.

Rigging hardware like this sees repeated use, so look for equipment that is properly rated, clearly marked, and traceable to a manufacturer that stands behind its specifications. Keeping documentation on hand for each piece of equipment also makes routine inspections and any future certification requirements easier to manage.

Full specifications are listed below so you can confirm fit against your current rigging before it ships.

The Machining & Welding 40000 LB 6 FT Fixed Spreader Beam is ready to spread your rigging and keep the next lift level.

Product Info:
•  Working Load Limit: 40,000 lbs
•  Beam Length: 6 ft
•  Connection: SHACKLE CONNECTIONS
•  Frame Material: Structural steel
•  Shipping Weight: 275 lbs