For loads too long or too heavy for one hoist, the Machining & Welding 4000 LB 6 FT Twin Hoist Lift Beam spans 6 feet and carries a 4,000 pound working load limit across two lift points.

By running two hoists on one beam, you can lift and lower each end independently, which is useful for tilting a load into position or leveling it as you go.

Swivel latch hooks reduce twisting in the chain or sling as the load is lifted, keeping the rigging aligned throughout the pick.

Independent control at each end of the beam makes it easier to tilt, rotate, or level a load precisely, which a single center hook cannot do.

From production floors to rail yards to municipal utility crews, this style of equipment gets used wherever a load needs to move safely between two points. Standardizing on purpose-built lifting equipment also makes training new operators easier, since the rigging setup stays consistent from lift to lift instead of changing based on whatever hardware happens to be nearby.

Good lifting practice starts before the load ever leaves the ground: confirm the working load limit fits the job, check that all hardware is in good condition, and keep the load centered to avoid uneven strain on the rigging. These habits matter as much as the equipment itself, and they cost nothing beyond a few extra minutes of attention before each pick, which is a fair trade for a safer shop floor.

Rigging hardware like this sees repeated use, so look for equipment that is properly rated, clearly marked, and traceable to a manufacturer that stands behind its specifications. Keeping documentation on hand for each piece of equipment also makes routine inspections and any future certification requirements easier to manage.

Full specifications are listed below so you can confirm fit against your current rigging before it ships.

The Machining & Welding 4000 LB 6 FT Twin Hoist Lift Beam is built for the long, awkward loads that a single center hook was never meant to handle.

Product Info:
•  Working Load Limit: 4,000 lbs
•  Beam Length: 6 ft
•  End Fittings: Swivel latch hooks
•  Style: Twin hoist, dual lift point
•  Frame Material: Structural steel
•  Shipping Weight: 140 lbs