The Machining & Welding 3/4 IN Wire Rope Thr Stud is a threaded terminal fitting sized for 3/4 inch wire rope, built from stainless steel.

This fitting is swaged onto the rope end during assembly, creating a permanent, rated termination that accepts standard threaded hardware on the other end.

Manufactured to consistent tolerances, the fitting swages onto the wire rope with a rated holding strength that matches the rope it is paired with.

These are precision components, and ordering the exact size and specification avoids a costly reswage if the fitting does not match your hardware.

This type of lifting equipment is common in facilities that move machinery, structural steel, crates, or bulky components as part of daily operations. Rather than treating each lift as a one-off problem, a dedicated piece of equipment turns it into a routine, repeatable task that any trained operator can complete quickly and safely.

Good lifting practice starts before the load ever leaves the ground: confirm the working load limit fits the job, check that all hardware is in good condition, and keep the load centered to avoid uneven strain on the rigging. These habits matter as much as the equipment itself, and they cost nothing beyond a few extra minutes of attention before each pick, which is a fair trade for a safer shop floor.

Durability matters as much as initial capacity when choosing rigging equipment, since hardware that wears unevenly or corrodes quickly ends up costing more over its service life. Choosing components built to recognized manufacturing standards is one of the simplest ways to avoid that added cost down the road.

The specifications below cover everything you need to check compatibility with your equipment.

Add the Machining & Welding 3/4 IN Wire Rope Thr Stud to your wire rope assembly parts inventory.

Product Info:
•  Wire Rope Diameter: 3/4 in
•  Material: Stainless steel
•  Shipping Weight: 5.51 lbs