Built from carbon steel, the Machining & Welding 3/4 IN Wire Rope Ferrule swages onto 3/4 inch wire rope to form a rated eye or splice.

This sleeve is swaged with a hydraulic press to permanently secure a wire rope loop, eliminating the need for clips or knots at the termination point.

The ferrule is manufactured to precise dimensions so the swage compresses evenly around the wire rope, distributing load across the full sleeve length.

Keeping the right size ferrule on hand for each wire rope diameter you work with speeds up assembly and repair work in house.

This type of lifting equipment is common in facilities that move machinery, structural steel, crates, or bulky components as part of daily operations. Rather than treating each lift as a one-off problem, a dedicated piece of equipment turns it into a routine, repeatable task that any trained operator can complete quickly and safely.

Good lifting practice starts before the load ever leaves the ground: confirm the working load limit fits the job, check that all hardware is in good condition, and keep the load centered to avoid uneven strain on the rigging. These habits matter as much as the equipment itself, and they cost nothing beyond a few extra minutes of attention before each pick, which is a fair trade for a safer shop floor.

Well-built rigging hardware holds its rated capacity through years of regular use, provided it is inspected and stored properly between jobs. A dry, organized storage area away from corrosive chemicals or extreme temperature swings goes a long way toward extending the service life of steel components.

Details on capacity, dimensions, and hardware are listed below for a quick comparison against your requirements.

Order the Machining & Welding 3/4 IN Wire Rope Ferrule sized to match your wire rope diameter and material.

Product Info:
•  Wire Rope Diameter: 3/4 in
•  Material: Carbon steel
•  Shipping Weight: 1 lbs