When a single hoist cannot safely support a load's length or weight, the Machining & Welding 20000 LB 10 FT Twin Hoist Lift Beam lets two hoists share the lift, spanning 10 feet at 20,000 pounds working load limit.

Two hoist trolleys ride along the top of the beam while the load hangs from swivel latch hooks below, letting operators fine-tune balance by adjusting each hoist independently.

The beam is fabricated from structural steel with swivel latch hooks at the load connection points, letting the rigging pivot naturally as the load shifts during the lift.

Independent control at each end of the beam makes it easier to tilt, rotate, or level a load precisely, which a single center hook cannot do.

Equipment like this shows up across a wide range of industries, from steel fabrication and machine shops to warehousing, construction, and vehicle service centers. Anywhere crews need to move a load overhead in a controlled, repeatable way, a purpose-built lift beam or crane keeps the job safer and faster than improvised rigging. Once a facility standardizes on the right lifting equipment for its typical loads, operators spend less time rigging and more time actually getting work done.

Good lifting practice starts before the load ever leaves the ground: confirm the working load limit fits the job, check that all hardware is in good condition, and keep the load centered to avoid uneven strain on the rigging. These habits matter as much as the equipment itself, and they cost nothing beyond a few extra minutes of attention before each pick, which is a fair trade for a safer shop floor.

Properly rated hardware, stored and maintained correctly, tends to outlast the equipment it gets paired with. Building a simple habit of checking condition before each use costs very little time and pays off in fewer surprises when a piece of rigging hardware is actually under load.

See the specifications below for the exact numbers you will want to check before ordering.

The Machining & Welding 20000 LB 10 FT Twin Hoist Lift Beam is ready to give your crew independent control over both ends of a long or heavy load.

Product Info:
•  Working Load Limit: 20,000 lbs
•  Beam Length: 10 ft
•  End Fittings: Swivel latch hooks
•  Style: Twin hoist, dual lift point
•  Frame Material: Structural steel
•  Shipping Weight: 725 lbs