The Machining & Welding 1/4 IN Wire Rope Thr Stud is a threaded terminal fitting sized for 1/4 inch wire rope, swaged onto a 1.5 inch stud with 9/16 inch coarse thread and a left-hand thread direction.

This fitting is swaged onto the rope end during assembly, creating a permanent, rated termination that accepts standard threaded hardware on the other end.

Consistent thread dimensions and swage geometry keep this fitting compatible with standard wire rope assembly equipment and mating hardware.

Getting the thread size, pitch, and hand correct matters, since a mismatched stud will not thread into its mating hardware even if the wire rope size is right.

From production floors to rail yards to municipal utility crews, this style of equipment gets used wherever a load needs to move safely between two points. Standardizing on purpose-built lifting equipment also makes training new operators easier, since the rigging setup stays consistent from lift to lift instead of changing based on whatever hardware happens to be nearby.

As with any lifting equipment, never exceed the rated working load limit, and inspect slings, hooks, shackles, and connection points before every use. Confirm compatibility with your hoist, crane, or trolley system before placing an order, and follow your facility's rigging and lockout procedures for every lift. A few minutes spent checking hardware condition and load balance up front is far cheaper than dealing with a dropped or shifted load later, and it keeps your team's daily routine consistent from one job to the next.

Durability matters as much as initial capacity when choosing rigging equipment, since hardware that wears unevenly or corrodes quickly ends up costing more over its service life. Choosing components built to recognized manufacturing standards is one of the simplest ways to avoid that added cost down the road.

Full specifications are listed below so you can confirm fit against your current rigging before it ships.

The Machining & Welding 1/4 IN Wire Rope Thr Stud is ready to terminate your wire rope with a threaded connection.

Product Info:
•  Wire Rope Diameter: 1/4 in
•  Stud Length: 1.5 in
•  Thread Size: 9/16 in
•  Thread Pitch: Coarse
•  Thread Hand: Left-hand
•  Material: Carbon steel
•  Shipping Weight: 0.28 lbs