The Machining & Welding 1/4 IN Wire Rope Thr Stud is a threaded terminal fitting sized for 1/4 inch wire rope, swaged onto a 1.5 inch stud with 1/2 inch coarse thread and a left-hand thread direction.

This fitting is swaged onto the rope end during assembly, creating a permanent, rated termination that accepts standard threaded hardware on the other end.

Manufactured to consistent tolerances, the fitting swages onto the wire rope with a rated holding strength that matches the rope it is paired with.

Getting the thread size, pitch, and hand correct matters, since a mismatched stud will not thread into its mating hardware even if the wire rope size is right.

Equipment like this shows up across a wide range of industries, from steel fabrication and machine shops to warehousing, construction, and vehicle service centers. Anywhere crews need to move a load overhead in a controlled, repeatable way, a purpose-built lift beam or crane keeps the job safer and faster than improvised rigging. Once a facility standardizes on the right lifting equipment for its typical loads, operators spend less time rigging and more time actually getting work done.

Good lifting practice starts before the load ever leaves the ground: confirm the working load limit fits the job, check that all hardware is in good condition, and keep the load centered to avoid uneven strain on the rigging. These habits matter as much as the equipment itself, and they cost nothing beyond a few extra minutes of attention before each pick, which is a fair trade for a safer shop floor.

Durability matters as much as initial capacity when choosing rigging equipment, since hardware that wears unevenly or corrodes quickly ends up costing more over its service life. Choosing components built to recognized manufacturing standards is one of the simplest ways to avoid that added cost down the road.

Details on capacity, dimensions, and hardware are listed below for a quick comparison against your requirements.

Order the Machining & Welding 1/4 IN Wire Rope Thr Stud sized to match your wire rope and mating hardware.

Product Info:
•  Wire Rope Diameter: 1/4 in
•  Stud Length: 1.5 in
•  Thread Size: 1/2 in
•  Thread Pitch: Coarse
•  Thread Hand: Left-hand
•  Material: Carbon steel
•  Shipping Weight: 0.16 lbs