The Machining & Welding 1/4 IN Wire Rope Ferrule is a swage ferrule sized for 1/4 inch wire rope, built from carbon steel.

Swage ferrules are a common way to terminate wire rope ends quickly and consistently, provided the correct tooling and technique are used during the swage.

The ferrule is manufactured to precise dimensions so the swage compresses evenly around the wire rope, distributing load across the full sleeve length.

A properly swaged ferrule can achieve close to the full breaking strength of the wire rope, which loose clips generally cannot match.

Facilities ranging from small machine shops to large distribution centers keep equipment like this on hand for the lifts that come up week after week. It is the kind of tool that earns its spot on the floor by saving time on every single pick, and it pays for itself quickly once it replaces improvised rigging on a recurring job.

Before putting any lifting equipment into service, verify it matches your hoist or crane setup and confirm the rated capacity covers your heaviest expected load with margin to spare. Routine inspection of welds, pins, and connection hardware helps catch wear before it becomes a safety issue. Keep a simple inspection log if your facility does not already have one, since tracking wear over time makes it easier to plan replacement before a part actually fails in use.

Properly rated hardware, stored and maintained correctly, tends to outlast the equipment it gets paired with. Building a simple habit of checking condition before each use costs very little time and pays off in fewer surprises when a piece of rigging hardware is actually under load.

Full specifications are listed below so you can confirm fit against your current rigging before it ships.

Order the Machining & Welding 1/4 IN Wire Rope Ferrule sized to match your wire rope diameter and material.

Product Info:
•  Wire Rope Diameter: 1/4 in
•  Ferrule Outer Diameter: 1 in
•  Ferrule Length: 1.25 in
•  Material: Carbon steel
•  Shipping Weight: 0.28 lbs