Built from stainless steel, the Machining & Welding 1/4 IN Wire Rope Ferrule swages onto 1/4 inch wire rope to form a rated eye or splice.

This sleeve is swaged with a hydraulic press to permanently secure a wire rope loop, eliminating the need for clips or knots at the termination point.

Consistent wall thickness and bore diameter keep the swage strength predictable from one ferrule to the next.

Keeping the right size ferrule on hand for each wire rope diameter you work with speeds up assembly and repair work in house.

Facilities ranging from small machine shops to large distribution centers keep equipment like this on hand for the lifts that come up week after week. It is the kind of tool that earns its spot on the floor by saving time on every single pick, and it pays for itself quickly once it replaces improvised rigging on a recurring job.

Rated capacity should always be treated as a hard limit, not a target, and a quick visual inspection before each lift is one of the simplest ways to keep a lifting operation safe. Make sure your operators are trained on the specific rigging setup this equipment requires, and confirm that anyone signing off on a lift understands how to read the working load limit and match it against the actual load being moved.

Durability matters as much as initial capacity when choosing rigging equipment, since hardware that wears unevenly or corrodes quickly ends up costing more over its service life. Choosing components built to recognized manufacturing standards is one of the simplest ways to avoid that added cost down the road.

See the specifications below for the exact numbers you will want to check before ordering.

The Machining & Welding 1/4 IN Wire Rope Ferrule is ready to swage onto your next wire rope assembly.

Product Info:
•  Wire Rope Diameter: 1/4 in
•  Ferrule Outer Diameter: 0.625 in
•  Ferrule Length: 1.25 in
•  Material: Stainless steel
•  Shipping Weight: 0.1 lbs