The Machining & Welding 1/4 IN Wire Rope Ferrule is a swage ferrule sized for 1/4 inch wire rope, built from carbon steel.

This sleeve is swaged with a hydraulic press to permanently secure a wire rope loop, eliminating the need for clips or knots at the termination point.

Material choice between carbon and stainless steel lets you match the ferrule to the wire rope's own material and the assembly's environment.

Matching ferrule material to wire rope material avoids galvanic corrosion between dissimilar metals in outdoor or wet environments.

From production floors to rail yards to municipal utility crews, this style of equipment gets used wherever a load needs to move safely between two points. Standardizing on purpose-built lifting equipment also makes training new operators easier, since the rigging setup stays consistent from lift to lift instead of changing based on whatever hardware happens to be nearby.

Good lifting practice starts before the load ever leaves the ground: confirm the working load limit fits the job, check that all hardware is in good condition, and keep the load centered to avoid uneven strain on the rigging. These habits matter as much as the equipment itself, and they cost nothing beyond a few extra minutes of attention before each pick, which is a fair trade for a safer shop floor.

Rigging hardware like this sees repeated use, so look for equipment that is properly rated, clearly marked, and traceable to a manufacturer that stands behind its specifications. Keeping documentation on hand for each piece of equipment also makes routine inspections and any future certification requirements easier to manage.

Full specifications are listed below so you can confirm fit against your current rigging before it ships.

Order the Machining & Welding 1/4 IN Wire Rope Ferrule sized to match your wire rope diameter and material.

Product Info:
•  Wire Rope Diameter: 1/4 in
•  Ferrule Outer Diameter: 0.625 in
•  Ferrule Length: 0.875 in
•  Material: Carbon steel
•  Shipping Weight: 0.07 lbs