The Machining & Welding 1/2 IN Wire Rope Thr Stud is a threaded terminal fitting sized for 1/2 inch wire rope, built from carbon steel.

This fitting is swaged onto the rope end during assembly, creating a permanent, rated termination that accepts standard threaded hardware on the other end.

Consistent thread dimensions and swage geometry keep this fitting compatible with standard wire rope assembly equipment and mating hardware.

Choosing the correct material and wire rope diameter matters, since a mismatched fitting will not swage correctly even if the general size looks close.

From production floors to rail yards to municipal utility crews, this style of equipment gets used wherever a load needs to move safely between two points. Standardizing on purpose-built lifting equipment also makes training new operators easier, since the rigging setup stays consistent from lift to lift instead of changing based on whatever hardware happens to be nearby.

Good lifting practice starts before the load ever leaves the ground: confirm the working load limit fits the job, check that all hardware is in good condition, and keep the load centered to avoid uneven strain on the rigging. These habits matter as much as the equipment itself, and they cost nothing beyond a few extra minutes of attention before each pick, which is a fair trade for a safer shop floor.

Well-built rigging hardware holds its rated capacity through years of regular use, provided it is inspected and stored properly between jobs. A dry, organized storage area away from corrosive chemicals or extreme temperature swings goes a long way toward extending the service life of steel components.

Full specifications are listed below so you can confirm fit against your current rigging before it ships.

Add the Machining & Welding 1/2 IN Wire Rope Thr Stud to your wire rope assembly parts inventory.

Product Info:
•  Wire Rope Diameter: 1/2 in
•  Material: Carbon steel
•  Shipping Weight: 2.4 lbs