Built from carbon steel, the Machining & Welding 1/2 IN Wire Rope Ferrule swages onto 1/2 inch wire rope to form a rated eye or splice.

Swage ferrules are a common way to terminate wire rope ends quickly and consistently, provided the correct tooling and technique are used during the swage.

Consistent wall thickness and bore diameter keep the swage strength predictable from one ferrule to the next.

Keeping the right size ferrule on hand for each wire rope diameter you work with speeds up assembly and repair work in house.

This type of lifting equipment is common in facilities that move machinery, structural steel, crates, or bulky components as part of daily operations. Rather than treating each lift as a one-off problem, a dedicated piece of equipment turns it into a routine, repeatable task that any trained operator can complete quickly and safely.

Good lifting practice starts before the load ever leaves the ground: confirm the working load limit fits the job, check that all hardware is in good condition, and keep the load centered to avoid uneven strain on the rigging. These habits matter as much as the equipment itself, and they cost nothing beyond a few extra minutes of attention before each pick, which is a fair trade for a safer shop floor.

Rigging hardware like this sees repeated use, so look for equipment that is properly rated, clearly marked, and traceable to a manufacturer that stands behind its specifications. Keeping documentation on hand for each piece of equipment also makes routine inspections and any future certification requirements easier to manage.

The specifications below cover everything you need to check compatibility with your equipment.

Add the Machining & Welding 1/2 IN Wire Rope Ferrule to your wire rope termination supplies.

Product Info:
•  Wire Rope Diameter: 1/2 in
•  Ferrule Outer Diameter: 1.25 in
•  Ferrule Length: 1.75 in
•  Material: Carbon steel
•  Shipping Weight: 0.57 lbs