Built from stainless steel, the Machining & Welding 1/2 IN Wire Rope Ferrule swages onto 1/2 inch wire rope to form a rated eye or splice.

Ferrules like this compress around a wire rope loop to form a rated eye termination, a standard method for creating slings and rigging assemblies in house.

Consistent wall thickness and bore diameter keep the swage strength predictable from one ferrule to the next.

Keeping the right size ferrule on hand for each wire rope diameter you work with speeds up assembly and repair work in house.

This type of lifting equipment is common in facilities that move machinery, structural steel, crates, or bulky components as part of daily operations. Rather than treating each lift as a one-off problem, a dedicated piece of equipment turns it into a routine, repeatable task that any trained operator can complete quickly and safely.

Good lifting practice starts before the load ever leaves the ground: confirm the working load limit fits the job, check that all hardware is in good condition, and keep the load centered to avoid uneven strain on the rigging. These habits matter as much as the equipment itself, and they cost nothing beyond a few extra minutes of attention before each pick, which is a fair trade for a safer shop floor.

Properly rated hardware, stored and maintained correctly, tends to outlast the equipment it gets paired with. Building a simple habit of checking condition before each use costs very little time and pays off in fewer surprises when a piece of rigging hardware is actually under load.

The full spec sheet is below, covering capacity, dimensions, and construction details at a glance.

The Machining & Welding 1/2 IN Wire Rope Ferrule is ready to swage onto your next wire rope assembly.

Product Info:
•  Wire Rope Diameter: 1/2 in
•  Ferrule Outer Diameter: 1.125 in
•  Ferrule Length: 2.375 in
•  Material: Stainless steel
•  Shipping Weight: 0.59 lbs