The Machining & Welding 1/16 IN Wire Rope Threaded Stud is a threaded terminal fitting sized for 1/16 inch wire rope, built from carbon steel.

Threaded studs like this terminate a wire rope end with a machine thread instead of a hook or eye, letting you thread the assembly directly into a fitting, turnbuckle, or clevis.

Consistent thread dimensions and swage geometry keep this fitting compatible with standard wire rope assembly equipment and mating hardware.

Choosing the correct material and wire rope diameter matters, since a mismatched fitting will not swage correctly even if the general size looks close.

This type of lifting equipment is common in facilities that move machinery, structural steel, crates, or bulky components as part of daily operations. Rather than treating each lift as a one-off problem, a dedicated piece of equipment turns it into a routine, repeatable task that any trained operator can complete quickly and safely.

Good lifting practice starts before the load ever leaves the ground: confirm the working load limit fits the job, check that all hardware is in good condition, and keep the load centered to avoid uneven strain on the rigging. These habits matter as much as the equipment itself, and they cost nothing beyond a few extra minutes of attention before each pick, which is a fair trade for a safer shop floor.

Well-built rigging hardware holds its rated capacity through years of regular use, provided it is inspected and stored properly between jobs. A dry, organized storage area away from corrosive chemicals or extreme temperature swings goes a long way toward extending the service life of steel components.

Details on capacity, dimensions, and hardware are listed below for a quick comparison against your requirements.

The Machining & Welding 1/16 IN Wire Rope Threaded Stud is ready to terminate your wire rope with a threaded connection.

Product Info:
•  Wire Rope Diameter: 1/16 in
•  Material: Carbon steel
•  Shipping Weight: 0.04 lbs