The Machining & Welding 10000 LB 18 FT Twin Hoist Lift Beam is built for tandem lifting with two hoists working together. At 18 feet long and rated to 10,000 pounds, it keeps a long or heavy load balanced between two lift points.

Two hoist trolleys ride along the top of the beam while the load hangs from swivel latch hooks below, letting operators fine-tune balance by adjusting each hoist independently.

Steel construction runs the full length of the beam, engineered to carry the rated working load limit whether the load is centered or distributed toward either end.

Splitting a long or heavy lift between two hoists reduces stress on any single point of rigging and gives you more control over how the load travels.

Equipment like this shows up across a wide range of industries, from steel fabrication and machine shops to warehousing, construction, and vehicle service centers. Anywhere crews need to move a load overhead in a controlled, repeatable way, a purpose-built lift beam or crane keeps the job safer and faster than improvised rigging. Once a facility standardizes on the right lifting equipment for its typical loads, operators spend less time rigging and more time actually getting work done.

As with any lifting equipment, never exceed the rated working load limit, and inspect slings, hooks, shackles, and connection points before every use. Confirm compatibility with your hoist, crane, or trolley system before placing an order, and follow your facility's rigging and lockout procedures for every lift. A few minutes spent checking hardware condition and load balance up front is far cheaper than dealing with a dropped or shifted load later, and it keeps your team's daily routine consistent from one job to the next.

Equipment that sees daily use benefits from a quick visual check every time it comes out of storage, not just during scheduled inspections. Catching a small issue, like surface corrosion or a bent component, before it becomes a larger problem keeps rigging hardware safe and in service longer.

See the specifications below for the exact numbers you will want to check before ordering.

Order the Machining & Welding 10000 LB 18 FT Twin Hoist Lift Beam for a beam built to coordinate two hoists on a single pick with confidence.

Product Info:
•  Working Load Limit: 10,000 lbs
•  Beam Length: 18 ft
•  End Fittings: Swivel latch hooks
•  Style: Twin hoist, dual lift point
•  Frame Material: Structural steel
•  Shipping Weight: 1005 lbs