The Machining & Welding 1-1/8 IN Wire Rope Thr Stud is a threaded terminal fitting sized for 1/8 inch wire rope, built from carbon steel.

Threaded studs like this terminate a wire rope end with a machine thread instead of a hook or eye, letting you thread the assembly directly into a fitting, turnbuckle, or clevis.

Manufactured to consistent tolerances, the fitting swages onto the wire rope with a rated holding strength that matches the rope it is paired with.

Choosing the correct material and wire rope diameter matters, since a mismatched fitting will not swage correctly even if the general size looks close.

Facilities ranging from small machine shops to large distribution centers keep equipment like this on hand for the lifts that come up week after week. It is the kind of tool that earns its spot on the floor by saving time on every single pick, and it pays for itself quickly once it replaces improvised rigging on a recurring job.

Good lifting practice starts before the load ever leaves the ground: confirm the working load limit fits the job, check that all hardware is in good condition, and keep the load centered to avoid uneven strain on the rigging. These habits matter as much as the equipment itself, and they cost nothing beyond a few extra minutes of attention before each pick, which is a fair trade for a safer shop floor.

Well-built rigging hardware holds its rated capacity through years of regular use, provided it is inspected and stored properly between jobs. A dry, organized storage area away from corrosive chemicals or extreme temperature swings goes a long way toward extending the service life of steel components.

Full specifications are listed below so you can confirm fit against your current rigging before it ships.

The Machining & Welding 1-1/8 IN Wire Rope Thr Stud is ready to terminate your wire rope with a threaded connection.

Product Info:
•  Wire Rope Diameter: 1/8 in
•  Material: Carbon steel
•  Shipping Weight: 18 lbs