The Machining & Welding 1-1/4 IN Wire Rope Thr Stud is a threaded terminal fitting sized for 1-1/4 inch wire rope, swaged onto a 6.25 inch stud with 2-1/2 inch coarse thread and a left-hand thread direction.

This fitting is swaged onto the rope end during assembly, creating a permanent, rated termination that accepts standard threaded hardware on the other end.

The stud is precision machined to match its rated wire rope diameter, with thread dimensions cut to standard specifications for a secure fit into mating hardware.

Getting the thread size, pitch, and hand correct matters, since a mismatched stud will not thread into its mating hardware even if the wire rope size is right.

Equipment like this shows up across a wide range of industries, from steel fabrication and machine shops to warehousing, construction, and vehicle service centers. Anywhere crews need to move a load overhead in a controlled, repeatable way, a purpose-built lift beam or crane keeps the job safer and faster than improvised rigging. Once a facility standardizes on the right lifting equipment for its typical loads, operators spend less time rigging and more time actually getting work done.

As with any lifting equipment, never exceed the rated working load limit, and inspect slings, hooks, shackles, and connection points before every use. Confirm compatibility with your hoist, crane, or trolley system before placing an order, and follow your facility's rigging and lockout procedures for every lift. A few minutes spent checking hardware condition and load balance up front is far cheaper than dealing with a dropped or shifted load later, and it keeps your team's daily routine consistent from one job to the next.

Rigging hardware like this sees repeated use, so look for equipment that is properly rated, clearly marked, and traceable to a manufacturer that stands behind its specifications. Keeping documentation on hand for each piece of equipment also makes routine inspections and any future certification requirements easier to manage.

Full specifications are listed below so you can confirm fit against your current rigging before it ships.

Order the Machining & Welding 1-1/4 IN Wire Rope Thr Stud sized to match your wire rope and mating hardware.

Product Info:
•  Wire Rope Diameter: 1-1/4 in
•  Stud Length: 6.25 in
•  Thread Size: 2-1/2 in
•  Thread Pitch: Coarse
•  Thread Hand: Left-hand
•  Shipping Weight: 24.69 lbs